Non-Woven Interlining for Jacket Pockets and Small Parts
A jacket contains several smaller sections that need support even when they do not require the structure of the main front panel. Pocket flaps, pocket edges and selected internal details must hold their intended shape during sewing and use. Non-woven interlining can be considered for these components because it provides reinforcement in a bonded-fibre construction. It is particularly useful when the manufacturer needs to stabilise a smaller section without selecting a heavier woven material for the entire garment.
The suitable grade depends on the size and function of the component. For jacket small parts, Double Ghoda's application guide lists 50–70 GSM. A pocket flap may need enough body to sit neatly, while another internal section may require less support. The outer fabric also matters. A heavier jacket fabric may need a different interlining grade from a lightweight material. Manufacturers should consider the desired shape, the amount of flexibility required and whether the reinforced section will be visible from the outside. The aim is to support the construction without creating an obvious difference in texture or stiffness.
Sample testing should reflect the actual component. Cut the interlining to the pattern shape and fuse it to a piece of the intended outer fabric. Once the sample has cooled, inspect the edges and surface for uneven bonding, bubbles or lifting. Then fold, sew or handle the piece as it would be during garment construction. For a pocket flap, check whether it retains a clean fold and sits correctly when attached. If the material makes the section too rigid, compare another grade or review the fusing process. Testing a small component before cutting a production batch can help avoid unnecessary material waste.
Double Ghoda supplies non-woven fusible interlining made from bonded polyester fibres, with PES single-dot coating. Its listed GSM range is 30–80, and the product is supplied in 100 cm width and 90-metre rolls. White and black are the available colours listed on the product page. If you manufacture jackets and need interlining for pockets or other small components, share the application and required GSM when enquiring. Comparing the specification with a sample of your garment fabric is the best starting point for selecting a suitable grade.



Comments
Post a Comment